Curvy Border Gift Card Holder

Affiliate links may be used in this post. I may receive a small commission at no extra cost to you if you make a purchase through my affiliate link

There will be a lot of gift cards sent this year because of the 2020 pandemic. So in this tutorial I want to show you how to make a gift card holder using a curvy border die.

Supplies, measurements and instructions are listed below

Measurements

• Cardbase is 11″ x 5-1/2 scored at 3-1/2″ and 7-3/4″

Instructions

1. Use the Curvy Border Die, making sure the decorative edge is facing right on both sides of card
2. Fold inside flap and tuck designer paper under it. Place the curvy die where it will cut the designer paper to match the flap
3. Glue the cut designer paper to the flap and trim
4. Decorate the front of the card
5. Glue the edges of the inside flap down to create a pocket.

Supplies

Product List