Affiliate links may be used in this post. I may receive a small commission at no extra cost to you if you make a purchase through my affiliate link
One of the coolest features of the Stampin’ Up! Stamparatus is its repetitive stamping ability. In this card tutorial, I’m going to show you how to create a real blizzard of fun with the new stamp set Snow is Glistening and the best stamping tool the Stamparatus.
For this card, you will need
Product List
Repetitive Stamping Measurements
- card base 8-1/2″ x 5-1/2″
- whisper white 4″ x 5-1/2″
- white velvet 3-1/2″ x 5″
Repetitive Stamping Instructions
- position your white cardstock on the Stamparatus and secure with magnets
- place blizzard of snow stamp face down in the top left corner of the cardstock
- lower stamparatus plate to pick up stamp
- ink stamp and then lower plate again to stamp
- move stamparatus plate two notches, ink again and stamp
- repeat two more notches, ink and stamp a third time
- place the falling snow stamp face down on the left edge of the cardstock just below the blizzard
- flip Stamparatus plate over and pick up stamp
- ink and stamp 3 times moving two notches each time
- cut out white velvet paper with the snow flurry die
- attach snow flurry with mini dimensionals
- stamp sentiment in the lower right corner of the cardstock
- stick rhinestones in the center of the snowflakes on the snow flurry
- Use large dimensionals to adhere card layer to card base
I hope you have a beautiful and creative day.

Leave a Reply